炭黑含量对阻燃抗静电聚乙烯流变性能及力学性能的影响

王晗, 鹿立新, 李亚飞

PDF(1238 KB)
PDF(1238 KB)
塑料科技 ›› 2024, Vol. 52 ›› Issue (04) : 39-42. DOI: 10.15925/j.cnki.issn1005-3360.2024.04.008
理论与研究

炭黑含量对阻燃抗静电聚乙烯流变性能及力学性能的影响

作者信息 +

Effects of Carbon Black Content on Rheological Properties and Mechanical Properties of Flame-Retardant and Antistatic Polyethylene

Author information +
History +

摘要

在阻燃聚乙烯中加入炭黑制备阻燃抗静电聚乙烯材料,研究炭黑含量对材料的导电性能、动态流变行为及力学性能的影响。结果表明:随炭黑含量的增大,材料的复数黏度(η*)、储能模量(G')和损耗模量(G'')均增大,但损耗角正切值(tan δ)下降。炭黑含量超过2.4%,复合材料形成逾渗网络,表现为高零切黏度。炭黑含量逐渐增大,材料表面电阻率下降,炭黑含量为2.4%,表面电阻率迅速降至3×108 Ω,黏弹逾渗点与导电逾渗点几乎一致(均在2%~3%之间)。随着炭黑含量的增加,材料的冲击强度降低,流动性变差。炭黑含量为2.4%时,材料缺口冲击强度达到10.5 kJ/m2,熔体质量流动速率为2.0 g/10 min(190 ℃/2.16 kg)。

Abstract

A flame-retarded anti-static polyethylene material was developed by adding carbon black into flame retardant polyethylene, and the effects of carbon black content on the electrical properties, rheological properties, and mechanical properties were investigated. The results show that the complex viscosity (η*), storage modulus (G') and loss modulus (G'') all increase with the increase of carbon black content, but the loss tangent (tan δ) decreases.. The carbon black content is more than 2.4%, and the composite forms an over-permeability network, which is characterized by high zero-cut viscosity. With the increase of carbon black content, the surface resistivity of the material decreases, the carbon black content is 2.4%, the surface resistivity rapidly decreases to 3×108 Ω, and the viscoelastic over-permeability point is almost the same as the conductive over-permeability point (both between 2%~3%). With the increase of carbon black content, the impact strength of the material decreases and the fluidity deteriorates. When the carbon black content is 2.4%, the notched impact strength of the material reaches 10.5 kJ/m2, and the melt mass flow rate is 2.0 g/10 min (190 ℃/2.16 kg).

关键词

阻燃聚乙烯 / 炭黑 / 导电性 / 流变行为 / 力学性能

Key words

Flame-retarded polyethylene / Carbon black / Electrical properties / Rheological behavior / Mechanical property

中图分类号

TQ325.1+2

引用本文

导出引用
王晗 , 鹿立新 , 李亚飞. 炭黑含量对阻燃抗静电聚乙烯流变性能及力学性能的影响. 塑料科技. 2024, 52(04): 39-42 https://doi.org/10.15925/j.cnki.issn1005-3360.2024.04.008
WANG Han, LU Li-xin, LI Ya-fei. Effects of Carbon Black Content on Rheological Properties and Mechanical Properties of Flame-Retardant and Antistatic Polyethylene[J]. Plastics Science and Technology. 2024, 52(04): 39-42 https://doi.org/10.15925/j.cnki.issn1005-3360.2024.04.008

参考文献

1
邵水源,赵小亮,昝丽娜.高密度聚乙烯阻燃抗静电性能研究[J].塑料科技,2015,43(2):42-46.
2
王佳蕾,霍毅欣,杨宇.聚乙烯塑料的微生物降解[J].微生物学通报,2020,47(10):3329-3341.
3
李亚飞,孙小杰,任月庆,等.阻燃抗静电聚烯烃板材的制备与性能研究[J].中国塑料,2022,36(8):23-27.
4
胡志.矿用无卤阻燃抗静电聚乙烯材料的研制[J].矿业安全与环保,2017,44(3):16-19.
5
陈一,刘石刚,肖澄月,等.改性纳米氢氧化镁/微囊红磷无卤阻燃HDPE的研究[J].高分子通报,2011,6:69-73.
6
吴伟明,高岩,张艳芬,等.氢氧化铝在聚乙烯中阻燃性能的研究[J].塑料工业,2008,36(增刊1):210-212.
7
左建东,李荣勋,冯绍华,等.十溴二苯乙烷协同三氧化二锑阻燃PE研究[J].现代塑料加工应用,2004,16(3):32-34.
8
沈芳,余聪,李庆华,等.基于机械球磨法的茂金属PE/石墨/碳纳米管导电复合材料的制备及性能研究[J].应用化工,2019,48(5):126-129.
9
LUO Y, XIONG S Y, ZHANG F, et al. Preparation of conductive polylactic acid/high density polyethylene/carbon black composites with low percolation threshold by locating the carbon black at the Interface of co-continuous blends[J]. Journal of Applied Polymer Science, 2021, 138: 50291-50301.
10
何全国.聚乙烯/金属锡导电复合材料的研究[J].云南化工,2010,37(4):25-27.
11
陈晖,王磊,郭振.碳系/高分子导电复合材料研究现状[J].塑料工业,2020,48(6):1-5.
12
张锴,冯杨,蔡青.抗静电聚乙烯复合材料的制备与性能[J].塑料工业,2020,48(7):15-18, 50.
13
刘欢,季铁正,陈婷.导电填料/高密度聚乙烯(HDPE)导电复合材料的研究进展[J].炭素技术,2015,34(1):6-9, 19.
14
MOACY P S, SHIRLEY N C, AMANDA M A, et al. Evaluation of the rheological and electrical percolation of high-density polyethylene/carbon black composites using mathematical models[J]. Polymer Engineering & Science, 2021, 61: 2105-2116.
15
REN D Q, ZHENG S D, WU F, et.al. Formation and evolution of the carbon black network in polyethylene/carbon black composites: Rheology and conductivity properties[J]. Journal of Applied Polymer Science, 2014, 131(7): 39953-39962.
16
LIANG J Z, YANG Q Q. Effects of carbon black content and size on conductive properties of filled high-density polyethylene composites[J]. Advances in Polymer Technology, 2018, 37: 2238-2245.
17
郭新,康乐,田山,等.丁基橡胶/单壁碳纳米管导电复合材料新型预分散熔融混炼工艺的研究[J].橡胶工业,2022,69(12):939-946.
18
YUAN Q, BATEMAN S A, WU D Y. Mechanical and conductive properties of carbon black-filled high-density polyethylene, low-density polyethylene, and linear low-density polyethylene[J]. Journal of Thermoplastic Composite Materials, 2009, 23(4): 459-471.
19
陈璐,白茹茹,李正辉,等.EVA增容碳黑填充聚乙烯体系力学性能及流变性能研究[J].宁波工程学院学报,2017,29(3):9-13.
20
朱玉明.聚丙烯/碳基填料复合材料的流变行为研究[D].太原:中北大学,2013.
21
杨玲玲,瞿小兰,汤璐,等.聚乙烯/炭黑复合体系电性能的研究[J].塑料科技,2023,51(3):47-50.
22
王勇,黄锐.炭黑预处理对炭黑/HDPE导电复合材料性能的影响[J].中国塑料,2002,16(10):41-45.
23
王帅,王克俭,马伊,等.一种阻燃抗静电聚丙烯的流变性能[J].化工学报,2017,68(8):3023-3029.
24
宋义虎,郑强.粒子填充高分子熔体的动态流变行为[J].高分子通报,2013,9:22-34.
25
齐兴国,丁乃秀,何美玲,等.炭黑填充聚乙烯导电复合材料的性能研究[J].工程塑料应用,2006,34(7):21-24.

评论

PDF(1238 KB)

Accesses

Citation

Detail

段落导航
相关文章

/