Impact response and post-impact compression behavior of two-dimensional triaxially braided carbon fiber composites

Yang SUN, Jian HUANG, Zhenqiang ZHAO, Haili ZHOU, Chao LI, Liquan ZHANG, Chao ZHANG

PDF(6724 KB)
PDF(6724 KB)
Journal of Materials Engineering ›› 2025, Vol. 53 ›› Issue (1) : 211-218. DOI: 10.11868/j.issn.1001-4381.2023.000867
RESEARCH ARTICLE

Impact response and post-impact compression behavior of two-dimensional triaxially braided carbon fiber composites

Author information +
History +

Abstract

The two-dimensional triaxially braided composites are prepared by the resin transfer molding process. The mechanical response of two-dimensional triaxially braided composite under high and low velocity impact are investigated through the air gun system and drop hammer impact test system with different energies. The delamination damage under different impact energies are obtained by ultrasonic C-scan to analyze the damaged failure characteristics. The behaviors of compression after impact are studied in combination with digital image correlation. It is shown that the damaged area of the two-dimensional triaxially braided composite increases proportionally with the low velocity impact energy， but the energy absorption increases almost 2 times. Severe damage occurs and extends along the axial fiber under impact with an energy of 6.7 J/mm， leading to a significant reduction in its residual strength. The ballistic limit velocity of the two-dimensional triaxial braided composite is about 138.5 m/s. The projectile is embedded in the plate. When the impact velocity is greater than the ballistic limit velocity， a rectangular hole is formed on the impact surface， and a tearing fracture can be observed on the back surface. The damage area decreases with the increase of the incident velocity.

Key words

two-dimensional triaxially braid / carbon fiber composite / high velocity impact / low velocity impact / compression after impact

Cite this article

EndNote

Ris (Procite)

Bibtex

Download Citations
Yang SUN , Jian HUANG , Zhenqiang ZHAO , et al . Impact response and post-impact compression behavior of two-dimensional triaxially braided carbon fiber composites. Journal of Materials Engineering. 2025, 53(1): 211-218 https://doi.org/10.11868/j.issn.1001-4381.2023.000867

References

List( Publishing order | Descend order by publishing year | Descend order by cited within ) Chart analysis
1
BUCHROITHNER A， HAIDL P， BIRGEL C， et al. Design and experimental evaluation of a low-cost test rig for flywheel energy storage burst containment investigation［J］. Applied Science， 2018， 8（2）： 2622.
本文引用 [1]
2
李军， 刘燕峰， 倪洪江， 等. 航空发动机用树脂基复合材料应用进展与发展趋势［J］. 材料工程， 2022， 50（6）： 49-60.
LI J， LIU Y F， NI H J， et al. Application progress and development trend［J］. Journal of Materials Engineering， 2022， 50（6）： 49-60.
本文引用 [1]
3
顾善群， 张代军， 付善龙，等. 碳纤维/双马树脂复合材料抗高速冲击性能［J］. 材料工程， 2021， 49（11）： 73-82.
GU S Q， ZHANG D J， FU S L， et al. Anti-high speed impact properties of carbon fiber/bismaleimide resin composites［J］. Journal of Materials Engineering， 2021， 49（11）： 73-82.
4
冯振宇， 迟琪琳， 崔怀天 等. 平纹机织与2.5D机织复合材料平板弹道冲击特性对比［J］. 航空学报， 2022， 43（5）： 425116.
FENG Z Y， CHI Q L， CUI H T， et al. Comparison of ballistic impact behaviors between plain woven and 2.5D woven fabric composite plates［J］. Acta Aeronautica et Astronautica Sinica， 2022， 43（5）： 425116.
本文引用 [1]
5
ZABALA H， ARETXABALETA L， CASTILLO G， et al. Impact velocity effect on the delamination of woven carbon-epoxy plates subjected to low-velocity equienergetic impact loads［J］. Composite Science of Technology， 2014，94： 48-53.
本文引用 [1]
6
ICTEN B， KIRAL B， DENIZ M. Impactor diameter effect on low velocity impact response of woven glass epoxy composite plates［J］. Composites Part B： Engineering， 2013， 50： 325-332.
本文引用 [1]
7
VILLANUEVA G， CANTWELL W. The high velocity impact response of composite and FML-reinforced sandwich structures［J］. Composite Science and Technology， 2004， 64（1）： 35-54.
本文引用 [2]
8
KIM J， SHAM M. Impact and delamination failure of woven-fabric composites［J］. Composite Science and Technology， 2000， 60（5）： 745-761.
本文引用 [2]
9
GRIFFITHS B. Composite fan blade containment case［J］. High-performance Composites， 2005（5）： 76-78.
本文引用 [1]
10
ROBERTS G D， PEREIRA J M， REVILOCK D M， et al. Ballistic impact of braided composites with a soft projectile［J］. Journal of Aerospace Engineering， 2002， 18（1）： 3-7.
本文引用 [1]
11
CHENG J. Material modeling of strain rate dependent polymer and 2D triaxially braided composites［D］. Akron： University of Akron， 2006.
本文引用 [1]
12
赵振强. 二维三轴编织复合材料的动态力学行为与失效机理［D］. 西安： 西北工业大学， 2019.
ZHAO Z Q. Dynamic mechanical behavior and failure mechanism of two-dimensional triaxially braided composites［D］. Xi’an： Northwestern Polytechnical University， 2019.
本文引用 [1]
13
LIU L， XUAN H， CHEN G， et al. Ballistic impact testing and analysis of triaxial braided composite fan case material［J］. Advanced Materials Research， 2012， 535/537： 121-132.
本文引用 [1]
14
沈真， 杨胜春， 陈普会. 复合材料抗冲击性能和结构压缩设计许用值［J］. 航空学报， 2007， 28（3）： 561-566.
SHEN Z， YANG S C， CHEN P H. Behaviors of composite materials to withstand impact and structural compressive design allowableness［J］. Acta Aeronautica et Astronautica Sinica， 2007， 28（3）： 561-566.
本文引用 [1]
15
沈真， 张子龙， 王进， 等. 复合材料损伤阻抗和损伤容限的性能表征［J］. 复合材料学报， 2004， 21（5）： 140-145.
SHEN Z， ZHANG Z L， WANG J， et al. Characterization of damage resistance and damage tolerance behaviour of composite laminates［J］. Acta Materiae Compositae Sinica， 2004， 21（5）： 140-145.
本文引用 [1]
16
王心淼， 陈利， 焦伟， 等. 多轴向三维机织复合材料的低速冲击力学性能［J］. 材料导报， 2020， 34（7）： 14191-14197.
WANG X M， CHEN L， JIAO W， et al. Low-velocity impact properties of multiaxial 3D woven composites［J］. Materials Reports， 2020， 34（7）： 14191-14197.
本文引用 [1]
17
YU L， JIN L， NIU Z， et al. Experimental investigation on the low-velocity impact damage of 3D angle-interlock woven composites［J］. Advanced Materials Research， 2012， 487： 793-797.
本文引用 [1]
18
刘鹏， 蔡应龙， 顾佳辉， 等. 基于红外热成像的编织复合材料低速冲击和冲击后压缩试验研究［J］. 爆炸与冲击， 2022， 42（6）： 063101.
LIU P， CAI Y L， GU J H， et al. Experimental research on low-velocity impact and compression after impact of braided composites based on infrared thermal imaging［J］. Explosion and Shock Waves， 2022， 42（6）： 063101.
本文引用 [1]

Comments

PDF(6724 KB)

Accesses

Citation

Detail
Sections
Recommended
Copyright © Journal of Materials Engineering, All Rights Reserved.
Powered by Beijing Magtech Co. Ltd.

/

〈 〉